User`s guide

Making Prints Using the Stack Bypass
2-51
2
Basic Operations
1 Open the stack bypass.
NOTE
If the paper size you are going to load in the stack bypass is different from the paper size stored
in Stack Bypass Standard Settings, set Stack Bypass Standard Settings to 'Off' in Common
Settings (from the Additional Functions screen). (See "Standard Paper for the Stack Bypass," on
p. 4-36.)
● If the paper you want to specify is already loaded in the stack bypass:
❑ Press [Paper Select] ➞ [Stack Bypass] ➞ select the paper size and type loaded in the stack
bypass.
❑ Proceed to step 6.
● If the paper loaded in the stack bypass is not the paper that you want to
specify:
❑ Check to see if any job is reserved. (See "Checking Job Status," on p. 5-6.)
If there is a current or reserved job, you can reserve a change of paper for the stack bypass.
(See Chapter 1, "Introduction to the Copying Functions," in the Copying and Mail Box
Guide.)
If there is no reserved job, remove any paper remaining in the stack bypass ➞ continue the
procedure from step 2.