User`s guide

Adjusting the Machine
4-55
4
Customizing Settings
NOTE
The Zoom Fine Adjustment feature of this machine is different from that of other Canon products.
For example, if the amount of fine adjustment for X (horizontal direction) and Y (vertical direction)
are both set at '+1.0%', the actual adjustments are as follows:
- Other Canon products:
Actual adjustment = zoom setting (%) + fine adjustment (%)
50%
➞ 51%
100%
➞ 101%
400%
➞ 401%
- The CLC3220/iR C3220N:
Actual adjustment = (100 + fine adjustment (%)) x (zoom setting (%))/100
50%
➞ 50.5%
100%
➞ 101%
400%
➞ 404%
Saddle Stitch Staple Repositioning
You can reposition the stapler of the saddle stitcher unit after clearing a staple jam, or after
replacing the staple cartridge. Saddle stitch staple repositioning works by feeding several
sheets of paper into the saddle stitcher unit and stapling them together.
CAUTION
If transparencies are loaded in a paper drawer, make sure to pull that drawer out slightly so
that transparencies are not fed for the saddle stitch staple repositioning procedure. Damage
to the machine may occur if transparencies are fed during this procedure.
IMPORTANT
• Saddle stitch staple repositioning can only be performed if the optional Saddle Finisher-N2 is attached.
• Only use A3 or A4R paper for the saddle stitch staple repositioning procedure.
• Make sure to remove all output booklets from the optional Booklet Tray before performing the saddle
stitch staple repositioning procedure.
NOTE
Paper that is required for the saddle stitch staple repositioning procedure is automatically fed to the
saddle stitcher unit by the machine.