User`s guide

AppleTalk Network Setup Procedures
6-2
6
Using an AppleTalk Network (Macintosh)
AppleTalk Network Setup Procedures
To print via an AppleTalk network, it is necessary to perform the following procedures.
1 Macintosh Network Settings (See "Macintosh Network Settings," on p. 6-3.)
Set up the Macintosh for connection to an Ethernet network.
2 Protocol Settings (See "Settings from the Control Panel," on p. 6-5.)
Specify the protocol settings. To specify the settings, use:
• The machine's control panel
• A web browser (Remote UI)
• NetSpot Device Installer (Canon utility)
• A web browser (NetSpot Console) (Canon utility)
3 Macintosh Print Settings (See "Setting Up a Computer for Printing," on p. 6-8.)
Specify the settings for each computer you use for printing.
IMPORTANT
• If you are using the optional Color Network Printer Unit, see the manual provided with the optional Color
Network Printer Unit.
• To print from a computer, the optional equipment must be installed. For the equipment needed, see
"Optional Equipment and System Environment Requirements," on p. 1-2.
• It is not possible to send a fax from a computer via an AppleTalk network.
• It is recommended that the network manager perform step 2 above.
• To configure settings with software other than the control panel of the machine, TCP/IP protocol must be
supported by your network environment.