User`s guide

Interface Settings
2-9
2
Settings Common to the Network Protocols
Interface Settings
You can specify the interface settings for the machine by using any of the following.
• The machine's control panel
• A web browser (Remote UI)
This section describes how to specify the settings from the control panel.
If you are using Ethernet to interface, see "Setting Up the Ethernet Driver," on p. 2-10.
If you are using Token Ring to interface, see "Setting Up the Token Ring," on p. 2-13.
IMPORTANT
• If you configure the interface settings for the first time, use the control panel of this machine. After
configuring the protocol settings, you can change the content by using a web browser (Remote UI).
• If you use Token Ring, it is necessary to purchase the optional Token Ring Network Interface Adapter.
• You cannot use Ethernet and Token Ring at the same time. When a Token Ring board is already
installed in the machine, you cannot use Ethernet. To use Ethernet, remove the Token Ring board from
the machine.
NOTE
For instructions on how to enter settings using a web browser (Remote UI), see Chapter 3,
"Customizing Settings," in the Remote UI Guide.