Service manual

Chapter 3
3-19
F-3-112
2) Disconnect the 2 flat cables [1], and remove the 2 fastons [2]; then, detach
the operation panel [3].
F-3-113
3.2.11 SCNT Board
3.2.11.1 Removing the Rear Cover
0007-8059
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
F-3-114
3) Open the reader assembly [4], and lift to free the 2 claws [5].
F-3-115
4) Close the reader assembly; then, detach the rear cover[1].
F-3-116
3.2.11.2 Removing the Scanner Unit
0007-8062
1) Remove the platen glass cover.
2) While removing the left and right claws, detach the hinge cover [1].
3) Remove the screw [2], and detach the cable guide [3].
F-3-117
4) Open the harness band [1], and free the 2 cables [2] connected to the
reader assembly.
F-3-118
5) Remove the 2 screws [1] from the back; then, shift the scanner unit [2] to
the back, and lift it to detach.
F-3-119
3.2.11.3 Removing the Board Unit
0012-7164
1) Remove the 8 screws [1] from behind the scanner unit, and shift up the
board unit [2].
[1]
[2]
[2]
[3]
[1][2] [2]
[3]
[2]
[3]
[1]
[3]
[4]
[5]
[2]
[3]
[1]
[3]
[2]
[1]
[3]
[2]
[2]
[1]
[2]
[1]