Service manual

Chapter 3
3-20
F-3-120
2) Open the board unit; then, disconnect the 6 connectors [1] and the 3 flat
cables [2].
F-3-121
3.2.11.4 Removing the SCNT Unit
0012-7165
1) Remove the two screws [1], and detach the support plate [2].
F-3-122
2) Remove the 2 screws [1], and detach the modular board cover [2].
F-3-123
MEMO:
Pay attention to the harness [3], as it is connected to the cover..
3) Remove the 4 screws [1], and open the NCU unit [2].
F-3-124
4) Disconnect the flat cable [1] and the connector [2].
F-3-125
5) Remove the screw [1], and disconnect the connector [2].
F-3-126
6) Remove the screw [1], and detach the retainer [2].
F-3-127
7) Disconnect the connector [1] and remove the lithium board [2].
F-3-128
8) Remove the screw [1], and detach the two cable retainers [2].
[1]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[2]
[1]
[3]
[2]
[2]
[1]
[1]
[1]
[2]
[2] [1]
[1] [2]
[2] [1]