Service manual

Chapter 3
3-37
F-3-235
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
F-3-236
3.2.17.9 Removing the Right Frame
0011-6592
1) Remove the 5 screws [1], and detach the right frame [2].
F-3-237
3.2.17.10 Removing the Left Frame
0007-7944
1) Remove the 4 screws [1], and detach the left frame [2].
F-3-238
3.2.17.11 Removing the Cassette Feeder
0007-7948
1) Lift the machine, and detach the cassette feeder [1].
F-3-239
3.2.17.12 Removing the Shield Plate
0011-6613
1) Free the flat cable [1] from the connector.
2) Remove the 6 screws [2], and detach the shielding plate [3].
F-3-240
3.2.17.13 Removing the Fan Duct
0007-7950
1) Disconnect the 4 connectors [1], and remove the 2 claws [2].
2) Slide the fan duct [3] in upward direction to detach.
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[1]
[1]
[2]
[1]
[2]
[2]
[3]
[1]