Service manual

Chapter 3
3-46
F-3-292
When attaching the top cover, be sure to match its 2 positioners [1] and the
2 cut-offs [2] of the face-down sub cover, while making sure that the paper
retainer [3] is not blocking the feed path.
F-3-293
F-3-294
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
F-3-295
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
F-3-296
3.2.19.8 Removing the Right Frame
0011-6594
1) Remove the 5 screws [1], and detach the right frame [2].
F-3-297
3.2.19.9 Removing the Shield Plate
0011-6615
1) Free the flat cable [1] from the connector.
2) Remove the 6 screws [2], and detach the shielding plate [3].
[4]
[1]
[1]
[2]
[3]
[1]
[2]
OK NG
Enlarged View of the Paper Retainer
[3]
[3]
[1]
[2]
[1]
[2]
[1]
[1]
[2]