Service manual

Chapter 3
3-50
F-3-316
F-3-317
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
F-3-318
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
F-3-319
3.2.20.8 Removing the Left Frame
0007-8809
1) Remove the 4 screws [1], and detach the left frame [2].
F-3-320
3.2.20.9 Removing the Fan Duct
0007-8876
1) Disconnect the 4 connectors [1], and remove the 2 claws [2].
2) Slide the fan duct [3] in upward direction to detach.
F-3-321
3.2.20.10 Removing the Cooling Fan
0007-8878
1) Remove the 2 claws [1], and detach the cooling fan [2].
[1]
[2]
OK NG
Enlarged View of the Paper Retainer
[3]
[3]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[1] [1]
[1][1]
[2]
[3]