Service manual

Chapter 3
3-54
F-3-345
5) Remove the 2 screws [1] from the back; then, shift the scanner unit [2] to
the back, and lift it to detach.
F-3-346
3.3.3.3 Removing the SCNT Board Unit
0007-8078
1) Remove the 8 screws [1] from behind the scanner unit, and shift up the
SCNT board unit [2].
F-3-347
2) Open the SCNT board unit; then, disconnect the 6 connectors [1] and the
3 flat cables [2].
F-3-348
3.3.3.4 Removing the ADF Unit
0007-8079
1) Open the ADF unit [1], and detach the stopper [2].
2) Remove the 3 claws [3], and detach the ADF front cover [4].
F-3-349
3) Remove the ferrite core [1] from behind the scanner unit; then, free the
harness from the tape [2].
F-3-350
4) Open the ADF unit [1] as shown; then, disengage it starting with the rear
and then the front.
F-3-351
3.3.3.5 Removing the operation Panel
0007-8080
1) Remove the 2 screws [1], and free the 2 claws [2] (left/right) to open the
operation panel [3].
F-3-352
2) Disconnect the 2 flat cables [1], and remove the 2 fastons [2]; then, detach
[2]
[2]
[1]
[2]
[1]
[1]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[4]
[1]
[2]
[1] [2]
[1]
[A]
[B]
[B]
[C]
[D]
[C]
[A]
[1]
[2]
[2]
[3]