Service manual

Chapter 3
3-68
F-3-449
3.3.9.5 Removing the operation Panel
0007-8087
1) Remove the 2 screws [1], and free the 2 claws [2] (left/right) to open the
operation panel [3].
F-3-450
2) Disconnect the 2 flat cables [1], and remove the 2 fastons [2]; then, detach
the operation panel [3].
F-3-451
3.3.9.6 Removing the Scanner Cover Unit
0007-8089
1) Remove the copyboard cover.
2) Remove the 2 screws [1].
3) Remove the 6 claws [2], and detach the scanner cover unit [3].
F-3-452
3.3.9.7 Removing the Flat Bed Motor Unit
0007-8090
1) Remove the screw [1], and detach the plate [2].
2) Remove the 2 screws [3], and detach the flat bed motor unit [5] while
paying attention to the drive belt [4] of the CCD unit.
F-3-453
3.3.10 Document Feed Motor
3.3.10.1 Removing the Rear Cover
0009-9011
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
F-3-454
3) Open the reader assembly [4], and lift to free the 2 claws [5].
[1]
[A]
[B]
[B]
[C]
[D]
[C]
[A]
[1]
[2]
[2]
[3]
[1][2] [2]
[3]
[1]
[2]
[2]
[3]
[2]
[1][2]
[4] [3] [5] [3]
[2]
[3]
[1]
[3]