Service manual

Chapter 3
3-70
F-3-463
4) Open the ADF unit [1] as shown; then, disengage it starting with the rear
and then the front.
F-3-464
3.3.10.5 Points to Note When Mounting the ADF Unit
0009-9015
Be sure to observe the following when mounting the ADF unit:
If the harness [1] is too taut, a break in the line can occur. Be sure there is
some slack when the ADF unit [2] is fully open.
F-3-465
3.3.10.6 Removing the Document feed motor
0009-8759
1) Remove the following claws in the order indicated, and detach the ADF
rear cover [3]: claw [1], claw [2], claw [3].
F-3-466
2) Remove the 2 screws [1], and detach the harness guide [2] and the
Document feed motor unit [3].
F-3-467
3) Remove the gear [1] and the 2 screws [2]; then, detach the Document feed
motor [3].
F-3-468
3.3.11 DS Sensor
3.3.11.1 Removing the ADF Paper Sensor
0010-3734
1) Remove the stopper [1], and fully open the ADF unit [2].
F-3-469
2) Remove the 2 screws [1], and detach the ADF inside cover [2].
[1] [2]
[1]
[A]
[B]
[B]
[C]
[D]
[C]
[A]
[1]
[2]
[1]
[2]
[3]
[4]
[1]
[2][3]
[
1]
[2]
[3]
[2]
[1]