Service manual

Chapter 3
3-114
F-3-744
3.5.10.11 Removing the Waste Toner Detection PCB
0007-8855
1) Disconnect the connector (J108) [1] of the DC controller box; then, free
the harness from the harness clamp [2].
2) Remove the screw [3], and detach the waste toner detection PCB.
F-3-745
3.5.11 Developing Rotary/Toner Level Detection PCB
3.5.11.1 Removing the Rear Cover
0007-8549
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
F-3-746
3) Open the reader assembly [4], and lift to free the 2 claws [5].
F-3-747
4) Close the reader assembly; then, detach the rear cover[1].
F-3-748
3.5.11.2 Removing the Reader Assembly
0007-8587
1) Open the reader assembly, and remove the left and right E-rings [1]; then,
pull out the pin [2].
F-3-749
When closing the reader assembly, be sure to push in the arm [1] first.
[1]
[1]
[2]
[2]
[3]
[2]
[1]
[1]
[2]
[2]
[2]
[3][4]
[2]
[3]
[1]
[3]
[4]
[5]
[2]
[3]
[1]
[3]
[2]
[1]
[2]
[1]