Service manual

Chapter 3
3-117
F-3-762
F-3-763
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
F-3-764
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
F-3-765
3.5.11.8 Removing the Right Frame
0011-6601
1) Remove the 5 screws [1], and detach the right frame [2].
F-3-766
3.5.11.9 Removing the Registration Clutch
0007-8826
1) Disconnect the connector [1], and open the harness band [2].
2) Remove the E-ring [3], and detach the registration clutch [4].
F-3-767
The connector on the registration clutch side is designed to prevent discon-
nection. If you have to detach the registration clutch, be sure to disconnect
the connector (J113) on the DC controller PCB side.
3.5.11.10 Removing the Main Drive Assembly
0007-8832
1) Shift down the drive release lever [1], and remove the gear [2].
[1]
[2]
OK NG
Enlarged View of the Paper Retainer
[3]
[3]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[1][2] [3][4]