Service manual

Chapter 3
3-118
F-3-768
2) Remove the 2 screws [1], and detach the front sub cover [2].
F-3-769
When mounting the main drive assembly, be sure to fit the gear [2] as shown
with the drive release lever [1] in down position (i.e., with drive engaged).
At this time, be sure that the position of the gear is correct so that it is fully
engaged with the gear of the drive release lever.
F-3-770
3) Disconnect the 3 connectors [1], and remove the 8 screws [2]; then, detach
the main drive assembly [3].
F-3-771
3.5.11.11 Removing the Rotary Drive Assembly
0007-8836
1) Disconnect the 4 connectors [1], and remove the 2 screws [2].
F-3-772
2) Disconnect the connector [1], and remove the 3 screws [2]; then, detach
the rotary drive assembly [3].
[1]
[2]
[1][2]
[1]
[2]
[1]
[1]
[2]
[2]
[3]
[2]
[1]
[2]
[1]
[1]
[1]