Service manual

Chapter 3
3-159
F-3-1030
Make sure that all cables on the fixing film unit are hooked into the fixing
separation guide when reassembling the guide. Especially the right-side ca-
bles are easy to be pinched unless properly
hooked into the guide.
F-3-1031
16) Lift the fixing film unit [1] up straight in horizontal position to take it out
of the fixing unit.
F-3-1032
3.7.3.4 Removing the Fixing Pressure Roller
0011-7564
1) Remove the pressure roller[1] from the fixing unit.
F-3-1033
3.7.4 Fixing Delivery Paper Sensor
3.7.4.1 Removing the Fixing Assembly
0011-7856
1) Turn the lever [1] of the fixing assembly 90 deg in the direction of the
arrow.
2) While holding the grip [2], slide out the fixing assembly [3] toward the
front and out of the machine.
Whenever you have to replace the fixing assembly, be sure to disconnect the
power cord first. Also, be sure to wait unit the fixing assembly has cooled
before removing it after disconnecting the power cord.
F-3-1034
3.7.4.2 Removing the Face-Up Cover
0011-7857
1) Turn the fixing lever [1] of the fixing assembly 90 deg in the direction of
the arrow.
2) Remove the 4 claws [2], and detach the face-up cover [3] from the fixing
assembly.
F-3-1035
3.7.5 Pre-Fixing Paper Detection Sensor
3.7.5.1 Removing the Rear Cover
0007-8885
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
F-3-1036
3) Open the reader assembly [4], and lift to free the 2 claws [5].
[1]
[2]
[1]
[2]
[1]
[1]
[1] [1][3] [2]
[1] [1]
[2]
[3]
[2]
[3]
[1]
[3]