Service manual

Chapter 3
3-164
3.7.5.14 Removing the Main Drive Assembly
0007-8900
1) Shift down the drive release lever [1], and remove the gear [2].
F-3-1062
2) Remove the 2 screws [1], and detach the front sub cover [2].
F-3-1063
When mounting the main drive assembly, be sure to fit the gear [2] as shown
with the drive release lever [1] in down position (i.e., with drive engaged).
At this time, be sure that the position of the gear is correct so that it is fully
engaged with the gear of the drive release lever.
F-3-1064
3) Disconnect the 3 connectors [1], and remove the 8 screws [2]; then, detach
the main drive assembly [3].
F-3-1065
3.7.5.15 Removing the Toner Tray
0007-8901
1) Remove the 2 claws [1], and detach the toner tray [2].
F-3-1066
3.7.5.16 Removing the Fixing Front Paper Sensor Spacer
0007-8902
1) Remove the fixing front paper sensor spacer [1].
F-3-1067
3.7.5.17 Removing the Fan Duct
0007-8903
1) Disconnect the 4 connectors [1], and remove the 2 claws [2].
2) Slide the fan duct [3] in upward direction to detach.
[1]
[2]
[1][2]
[1]
[2]
[1]
[1]
[2]
[2]
[3]
[2]
[1]
[1]
[2]
[1]
[1]