[Mac] ScanGear MF User's Guide (V2.10.0)

Scanning from an Application

This explains the basic procedure for scanning using ScanGear MF from an application such as image editing

software.

Set the original in the device.

Set the device to online.

If [System Management Settings] > [Auto Online for Remote Scan] is disabled, select [Scan] > [Remote

Scanner] from the scan functions screen and set it to online. For details, refer to the manual of the device.

Select the scanning functions from the menu of the application → select the device.

The ScanGear MF dialog box is displayed.

The procedure displayed in the ScanGear MF dialog box may vary according to the application.

Congure the scan settings in either the [Simple Mode] or [Advanced Mode] panel and

click [Scan].

When scanning is complete, the image is read into the application.

NOTE

● You may not be able to scan from the second original onward, or an error message may be displayed after

you scan an original. If this happens, set each original one at a time and rescan.