[Windows] UFR II/UFRII LT Printer Driver Installation Guide (V21.75)

Selecting [Custom] to Install

This explains the procedure for manually specifying the port to use for a network connection or local connection

and installing the driver. As well as existing ports, you can add a standard TCP/IP port or network printer port.

Prerequisites

Conrm that the following conditions are satised. Complete the preparation operations.

● System and Service Requirements(P. 15)

● Installation Preparations and Precautions(P. 17)

● Conrm the port to be specied

Specify a standard TCP/IP port or a network printer port. You can specify an already registered port. You can

select a temporary port ([LPT1] etc.) and set it after installation is complete.

● Conrm the name and IP address of the device (if adding a standard TCP/IP port).

You must enter the device name and IP address when adding a standard TCP/IP port and installing. For the

name of the device, use the name by which the device is known on the network. If you do not know the

device name or IP address, check with your network administrator.

● Conrm the queue specied for each port (if the target device is shown in the following).

If an optional external print server unit is attached to the target device, after selecting the port, you must

specify the queue. Click "Open details," and conrm the queue corresponding to the selected port.

Specify the queues corresponding to the port.

For LPR:

For Windows TCP/IP, enter a Print, Hold, and Direct queue name in the [Queue Name] column.

For RAW:

The queue to be specied is determined by the port number.

9100: Print, Hold, or Direct

9101: Direct queue

9102: Print queue

9103: Hold queue

For SMB:

When you select the device from the network tree, three queues are displayed. Select one from among the

displayed queues.

● When starting the computer, log on as a member of Administrators.

● [Desktop] screen display (when using Windows 8/8.1/Server 2012/Server 2012 R2)

Procedures

Start the installer.

If you are using an installer downloaded from the web site

Double-click the downloaded le to decompress it. If the installer does not start automatically after it is

decompressed, double-click [Setup.exe].

If you are using the accompanying CD-ROM

(1) Set the CD-ROM in the computer → click [Installation].

Installation Using the Installer