[Windows] UFR II/UFRII LT Printer Driver Installation Guide (V21.75)

Cannot discover a device connected via a WSD port

This explains what to do if the device is not displayed in the [Printer List] of the installer even if it is connected

and discovered via a WSD port, when installing with a network connection.

A number of causes can be considered. Change the settings as required while referring to each "Remedy."

Cause 1.

The settings of the device have not been congured correctly.

Remedy

Check whether the following have been set at the device. If they have not been set, change the settings.

● Both [Use WSD] and [Multicast Discovery Settings] are set to ON.

● "UFR II," "PCL6," or "PS3" is selected for [PDL Selection (Plug and Play)].

For details, refer to the manual of the device.

Cause 2.

The network settings of the operating system have not been congured correctly.

Remedy

Check whether the necessary settings have been congured in the network settings of the operating system.

If they have not been set, change the settings.

In Windows 10

[Settings] > [Network & Internet] → click an icon displayed in the connection method to the current network →

enable [Make this PC discoverable].

In Windows 7/8/8.1/Server 2012/Server 2012 R2

From the [Desktop] screen, display the charm bar → [Settings] > [Change PC settings] > [Network] → click an

icon displayed in the connection method to the current network → enable [Find devices and content].

In Windows Vista/Server 2008

[Control Panel] > [Network and Internet] > [Network and Sharing Center] → click the button displayed to the

right of [Network Discovery] in [Sharing and Discovery] → select [Turn on network discovery].

Cause 3.

The device is not displayed in the discovery results because the driver corresponding to the discovered

device is already installed.

Remedy

If you want to install a driver by discovering a device, uninstall the driver rst, then discover it again.