Generic Plus UFR II Printer Driver v1.21 Installation Guide for Windows (pdf)

Changing the Port

This explains the procedure for changing the port used by a device connected to a network.

If you temporarily set a port for the device when installing the driver, change it to the correct port by following

this procedure.

Here, the method for creating a Raw or LPR port using a standard TCP/IP port is explained.

Prerequisites

● Driver installation

● Conrm the name or IP address of the device (if adding a standard TCP/IP port).

To add a standard TCP/IP port, you need to enter the name or IP address of the device. For the name of the

device, use the name by which the device is known on the network. If you do not know the device name or IP

address, check with your network administrator.

● Determining the protocol to use

Raw: A protocol that can be used with Windows. It transmits data at a higher speed than LPR.

LPR: The protocol commonly used by TCP/IP.

● When starting the computer, logon as a member of Administrators.

Procedures

Display [Devices and Printers] from the [Control Panel] of Windows.

Right-click the icon of the device you are going to set → select [Printer properties].

Display the [Ports] sheet → set the port.

Changing Settings to Match the Usage Environment