[Windows] Generic Plus UFR II Printer Driver User's Guide (V1.02)

Spools print data in EMF format. When printing from an application, this shortens the time taken for the
application to send the data to the printer.
When spooling in EMF format, problems such as the printed result differing from the image shown on the
monitor, and more time being required for printing than normal, may occur depending on the application being
used. If such problems occur, change the setting for [EMF Spooling] to [Off].
[Invalidate Passthrough]
Disables the passthrough function of the printer driver. If you cannot print from an application that sends print
data directly to the device, disabling passthrough may make printing possible.
[Print Mixed Color/B&W Documents at High Speed]
This function reduces the print time when printing data that contains a mixture of color pages and grayscale
(black and white) pages.
[Print Last Page in 1-sided Mode When 2-sided Printing is Set]
When using 2-sided printing to output print data containing an odd number of pages, this function prints the
last page in 1-sided print mode to reduce the print time.
[Special Fine Line Processing]
Corrects ne lines when printing so that they are thicker.
[Off]
Prints without correcting.
[Mode 1]
Corrects lines of less than two dots in width to a thickness of two dots when printing.
[Mode 2]
Corrects lines and rectangles of less than two dots in width to a thickness of two dots when printing.
[Mode 3]
Corrects lines and rectangles of less than three dots in width to a thickness of three dots when printing.
[Barcode Adjustment Mode]
In cases where barcode printing is unsatisfactory, such as when a barcode on a printed article is unreadable,
this function adjusts the thickness of the printed lines.
[Special Print Mode [Plain Paper]]
Solves xing problems such as curling when printing with plain paper.
[Printing Start Side]
Sets which side printing starts from when performing 2-sided printing.
Use this function if pages are not printed from the intended page source or on the intended page type when
performing 2-sided printing. The pages may then be printed correctly.
[Printing Start Position Settings]
Shifts the starting point for printing data in the long edge (upward) and short edge (rightward) directions. This
function is useful for adjusting margins when the widths of the top and bottom margins and right and left
margins differ, and for hiding the header information of faxes.
[Details] > [Printing Start Position Details] Dialog Box
Enables you to specify print starting positions.
[Increase Print Speed for Forms]
Use this function with the [Printer Default] setting.
[Restore Defaults]
Returns all the settings to their default values.
Settings List
106