Getting Started Guide

9
You can perform color
correction by selecting
<Yes> to obtain optimum
copy results or printout
results. For details on the
procedure, see the following
"Performing Color
Correction."
•
Adjust image to
reproduce original
color?
NoYes
Press [OK].
Use the numeric keys,
and then press [OK].
Move the cursor with [ ] or [ ].
Switch to <AM> or <PM> with
[ ] or [ ].
•
•
Current Time Settings
2010 01/01 12:52 AM
Check and press [OK].
Check that paper is
loaded in Drawer 1.
Next
Performing Color Correction
Make sure that paper is loaded,
and then press [OK].
Confirm the procedure for color
correction, and then press [OK].
Open the feeder. Place the test chart with the print
side face down.
Place the paper so that the black stripe
is at the back side of the machine.
Supported paper:
Size: A4, LTR, 16K
Type: Plain 1/2, Rec
OK
Steps (Start:Press OK)
1. Print Adj. Image 1
2. Scan Adj. Image 1
Step 1
Printing adj. image 1.
Close the feeder.
A test chart (adjusted image 1) is printed.
Press [
] (Start).
Place adj. image 1 on
the glass with black
side toward the back.
Press [Color] start.
Step 2
Scanning adj. image 1.
Copy Image Adjustment
Copy: Press Start
100% LTR
Density: 0
Original Type: Text...
Copy Ratio: 100% Di...
1
+
-
1
An initial screen appears, and initial
setting is finished.
Remove the test chart (adjusted image 1) placed on the platen glass in Step .
Preface
1
Installing the Machine
2
Configuring and Connecting the Fax
3
Connecting to a Computer and
Installing the Drivers
4
Appendix
Color correction takes approximately 255 seconds.
Check the temperature of the installation site.
If the room temperature is low, correction may not be
performed properly.
If <Adjustment failed.> appears
Is the paper loaded correctly?
Load plain paper or recycled paper of A4/Letter size in the paper
cassette.
Is the test chart placed on the platen glass correctly?
Place the test chart with the print side face down and the black
stripe toward the back of the machine.
Has a paper jam occurred?
Remove the jammed paper.
If you want to perform color correction again, press [ ]
(Menu), and then select the following settings in the following
order.
<Adjustment/Cleaning> → <Auto Gradation Adjustment> →
<Copy Image Adjustment>
•
→
•
→
•
→
If <Open the back cover, remove the
protective sheet.> appears
The packing materials inside the back
cover has not been removed.
Refer the procedure of "2. Remove
the packing material" in P.4 to
remove them.