Getting Started Guide

27
Checking the IP Address
Check the network operation.
Select with [ ] or [ ], and
then press [OK].
Press [ ] (Status Monitor/Cancel).
Press [OK].
Select with [ ] or [ ],
and then press [OK].
Check the IP address.
Press [ ] (Status
Monitor/Cancel) to
close the screen.
Enter "http://<IP address of the machine>/" in the address field, and then
press the [ENTER] key on your keyboard.
Start the web browser of a
computer which is connected
to a network.
Check that the screen of the Remote UI is displayed.
When the Remote UI is not displayed
Check the following.
Whether the computer and hub are connected using a LAN cable
Whether <Remote UI On/Off> is set to <On>
e-Manual "System Settings"
•
•
Status Monitor/Cancel
Copy Job Status
Fax Job Status/Hist...
Print Job Status/Hi...
Network Information
Network Information
IPv4
IPv6
IPv4
IP Address
Subnet Mask
Gateway Address
Host Name
IP Address
192.168.0.215
The < IP address of the machine> is the
address checked in Step
.
Input Example: http://192.168.0.215/
When the machine is connected to a switching hub
You may not be able to connect the machine to a network even
though your network settings are appropriate. Delaying the
machine's network startup time may solve the problem.
e-Manual "Specifying the Wait Time until the Machine Connects
to a Network"
Preface
1
Installing the Machine
2
Configuring and Connecting the Fax
3
Connecting to a Computer and
Installing the Drivers
4
Appendix
A-3
If the IP address displayed on the screen is between
"169.254.1.0 and 169.254.254.255"
This IP address is the one assigned by the AutoIP function.
If an IP address other than link-local addresses is set for the
computer, set an IP address in the same subnet as the computer
(other than link-local addresses) also for this machine manually.
This enables the installer to search for this machine.
e-Manual "Setting IPv4 Address"
e-Manual "Setting IPv6 Address"