Manualshelf

Technical information

ManualsBrandsCanon ManualsProjectorColorPASS-Z40e
31323334353637383940
COPYRIGHT
©
2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 3 INSTALLATION
3-1
1 Installation
1.1 Preliminary Checkout
Once you have unpacked or serviced the ColorPASS, power it up before you connect it to
the copier and the network. Diagnostics are run automatically during startup to check the
ColorPASS for internal problems.
The following procedure describes how to connect power to the ColorPASS.
1.1.1 To Connect Power and Start the ColorPASS
1. Connect the recessed end of the ColorPASS power cable to the power connector at the
side of the ColorPASS (see F03-101-01).
2. Make sure the ColorPASS power switch is in the off position (press 0), and then connect
the other end of the ColorPASS power cable to a wall outlet.
F03-101-01 ColorPASS power
Power switch
Power connector
Side panel