Technical information

COPYRIGHT © 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-12
5 Electrical Parts
5.1 Outline
This section includes procedures for removing and replacing the following boards:
• SCSI board
• Video board
• UIB board
• Ethernet board
• Motherboard
For information on installing option boards, see the separate installation instructions pro-
vided with that board.
5.2 SCSI Board
The SCSI board in the Color PASS provides the interface between the ColorPASS and the
external CD-ROM drive. The SCSI board is installed in connector PCI1 on the ColorPASS
motherboard.
F04-502-01 SCSI board layout
5.2.1 To Remove the SCSI Board
1. Power off and open the ColorPASS as described in “To shut down the ColorPASS” on
page 4-4 and “To open the ColorPASS” on page 4-5.
2. Remove the board mounting bracket screw from slot 1.
3. Remove the SCSI board from motherboard connector PCI1.
Grasp the board at the front and back edge and gently pull the board straight out of its
connector on the motherboard.
4. Place the board in an antistatic bag.
To motherboard connector PCI1