Technical information
COPYRIGHT
©
2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-27
5.7.5 Motherboard jumpers
The following section describes the locations and settings for the jumpers on the
motherboard.
Memo
The jumpers in the table below show the current shipping configuration.
T04-507-01
Jumper Jumper area Description
(shipping configuration)
JP1 • Bus speed settings.
• Jumper installed on pins 1 and 2.
JP2 • Clear CMOS and reset password.
• Jumper installed on pins 1 and 2 during normal opera-
tion. To reset the CMOS to the BIOS defaults, move
the jumper to pins 2 and 3, reboot, and then replace
jumper to pins 1 and 2.
JP10 • CPU speed settings.
• Jumper installed on pins 1 and 2. This setting should
not be changed.
JP11 • CPU speed settings.
• Jumper installed on pins 1 and 2. This setting should
not be changed.
JP12 • CPU speed settings.
• Jumper installed on pin 1. This setting should not be
changed.
JP13 • CPU speed settings.
• Jumper installed on pin 1. This setting should not be
changed.
1
2
3
1
2
3
1 2
1 2
1 2
1 2