Technical information

COPYRIGHT © 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-33
b. To Replace the Power Supply
1. Align the power supply with the mounting holes in the tray.
2. Replace the four mounting screws you removed earlier.
If the replacement power supply is shipped with screws, make sure to use those screws
to secure the power supply to the tray.
3. Connect the following power supply cable connectors:
• 20-pin power cable to the motherboard power connector (PWR CON).
• Large 4-pin power cable to the power connector on the HDD.
4. Reassemble the ColorPASS and verify its functionality (see “Restoring ColorPASS
functionality after service” on page 4-10).
If you cut any tie wraps, make sure you replace them.