User's Manual

5) Detach the transfer roller and the static eliminator.
6) Detach the transfer guide.
7) While butting the two heaters against the transfer guide as shown in Figure 4-326, fix
them in place using two screws e; then, fix the harness using two harness bands r
(front, rear).
8) Fix the harness with two SK binders t (front, rear) in place, and insert it into the
transfer guide.
Figure 4-326
Caution:
When fixing the harness in place, make sure that the cap portions of the terminal
are alternated as shown in Figure 4-327; if bundled in parallel, the harness will
come into contact with the transfer roller.
Figure 4-327
COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4-45