User's Manual

8. Positioning the Multifeeder Assembly (paper guide plate cam)
Temporarily fix the screw equipped with a hex nut on the spring clutch assembly, and
rotate the control ring. Make adjustments so that the hole in the cam and the hole in the
multifeeder drive unit match as shown in Figure 5-725 when the claw is engaged with the
solenoid plate; then, fix in position.
Figure 5-725
COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 PICK-UP/FEEDING SYSTEM
5-29