User's Manual

6) Close the cover.
7) Connect the connector on the relay harness to the connector of the cassette heater
(rear side plate of the cassette feeding unit). (Connect the side where the harness
is bundled with a tie-wrap.)
Figure 8-605
8) Install the cord clamp to the hole in the rear side plate of the cassette feeding
unit/pedestal.
• Cassette Feeding Module-A2
Figure 8-606
COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
8-22
CHAPTER 8 INSTALLATION
Connector
Cord clamp
Tie-wrap
Cord clamp