Specifications

ENGLISH
1 2
GENERAL MAINTENANCE P.1
BEFORE USING THE PRINTER FOR FIRST TIME P.1
BEFORE STARTING P.1
DECIMAL POINT SELECTOR SWITCH P.2
ROUNDING SWITCH P.2
CONSTANT SWITCH P.2
ACCUMULATION SWITCH P.2
ITEM COUNT / AVERAGE CALCULATION SWITCH P.2
PRINT / PAIR MODE CALCULATION SWITCH P.3
STORE / RECALL MEMORY KEY P.3
RECALL ITEM COUNT / ITEM PLUS KEY P.4
OVERFLOW FUNCTION  P.4
SPECIFICATIONS P.4
CARRYING HANDLE P.4
REPLACING THE INK RIBBON P.5
INSTALLING PRINTING PAPER P.5
CALCULATION EXAMPLE P.16-24
CONTENTS
 – Used for designating the decimal point position
  (F, 6, 4, 3, 2, 1, 0, +1, +2) for calculated results.
 F (Floating Decimal point) – All effective numbers up to 10
digits (CP1013D II) or 12 digits (CP1213D II) are printed or
displayed.
 +1, +2 (Add-Mode) – Addition & subtraction (+1) or
Multiplication (+2) functions are performed with an 2-digit
decimal. It is convenient for currency calculations.
GENERAL MAINTENANCE
BEFORE USING THE PRINTER FOR FIRST TIME
DECIMAL POINT SELECTOR SWITCH
 – Used for round-up [ ] , round-off [5/4], or round-down
[ ] to the pre-selected decimal digits in the result.
ROUNDING SWITCH
ITEM COUNT / AVERAGE CALCULATION SWITCH
 – Set the switch to "K" for performing multiplication and
division by a constant.
CONSTANT SWITCH
 – Set the switch to "AM", the entered number will be
automatically accumulated in the memory regiter by
pressing the key
ACCUMULATION SWITCH
 Do not use or leave the calculator under direct sunlight. Areas subject to rapid
temperature changes, high humidity, dust and dirt should also be avoided.
 Use a dry cloth to clean the casing of the unit. Do not use water or detergents.
 Only use the printer when the paper roll is loaded.
 Avoid using the calculator in places where there are iron filings, as this may
affect the electrical circuits of the calculator.
 Do not place anything on top of the machine, particularly on top of the printer
mechanism.
 Turn the calculator off before removing the plug from the electrical outlet.
 In case of electrical fault (i.e. smoke), disconnect the plug from the electrical
point immediately. The socket outlet should be near to the equipment and
easily accessible.
Remove the tape on the ink ribbon of the
calculator before use.
BEFORE STARTING
1)Plug in AC power cord. (Figure a )
2)Turn power switch on. (Power switch is located on
 the right side of the cabinet.) "C" will automatically
 be printed on the paper if the switch is set to print.
(Figure b )
1) 2)
At "n+" or "n+/–" position, the calculator count and print the
number of calculation items up to 9999.
<ITEM COUNTER>
When the "ITEM" switch is set at "n+", the calculator counts
the number of times the and keys are pressed.
When the switch is set at "n+/–", the calculator counts the
number of times the key is pressed and subtracts from
the total numbers of times the key is pressed.
<MEMORY ITEM COUNT>
When the "ITEM" switch is set at "n+", the calculator counts
number of times and keys are pressed.
When the switch is set at "n+/–", the calculator counts the
number of times the key is pressed and subtracts from
the total number of times the key is pressed.
5/4
a
b