Product specifications

DC10 E, DC20 E

SERVICE MODE / ADJUSTMENT

Procedure)

(1) Referring to the table shown below, check the internal temperature sensor in the camera.

(Be sure to perform this step immediately after power-on.)

(2) Using the internal camera temperature data, and record the current internal temperature.

Temperature immediately after power-on T1 = ______________

Note)

(1) In cases where the procedure has been interrupted, the internal camera temperature data recorded will be usable as reference data at

the time of restart.

• Internal camera temperature difference T [°C] = (Current internal camera temperature) - (Internal camera tempera-

ture at CCD image adjustment (low temperature)

• The value of the internal camera temperature difference is represented in decimal notation. When the value is

negative, it will blink. (The value does not blink if it is positive.)

• Changes in the internal camera temperature difference will cause the background color to change. As the internal

temperature of the lens increases, the background color changes as follows: blinking in yellow→white→ yellow→green.

Note: Until CCD image adjustment is carried out at a service center, a value of internal camera temperature difference

is indicated according to the "Internal camera temperature at CCD image adjustment (low temperature)" data

recorded at the time of pre-adjustment in the manufacturing process.

Fig. 12

Internal camera temperature difference

STEP PROCEDURE Microcomputer operation

TEMPERATURE CHECK CS Function MD ADDR DT

1 1) Make the setting shown at right. 0 02 ST 00D0 08 Completion of internal camera temperature sensor

2) Perform storing.

↑↑

check indication.

(press the PAUSE button.) Adjustment is completed.

2 Press SLOW KEY for transition to the normal mode. Indication of internal camera temperature

MONITOR