Product specifications

DC10 E, DC20 E

SERVICE MODE / ADJUSTMENT

5-4 IS Section Adjustment

Note)

(1) Perform the IS adjustment after machine is re-assembled to a product status.

(2) Prepare a tripod or stable work bench.

(3) Each of the adjustment data (5-4-1) becomes valid when 5-4-2 data writing is made. After completion of each adjustment, be sure

to carry out 5-4-2 before turning power OFF.

5-4-1 Gyro Offset Adjustment

SPEC. Automatic adjustment

Procedure)

(1) Wait at least 10 seconds while being careful not to apply vibration to the camera.

(2) Referring to the table shown below, perform the automatic adjustment.

Note)

It will take approx. 25 seconds at maximum to complete adjustment (OK) after storing (pressing the pause button).

B7 : Yaw Gyro gain

B6 : Pitch Gyro gain

77 : Yaw Gyro offset

79 : Pitch Gyro offset

7977B6B7

Fig. 18

STEP PROCEDURE Microcomputer operation

GYRO OFFSET CS Function MD ADDR DT ST

1 1) Make the setting shown at right. 2 08 ST 320D 00

2) Perform storing.

↑↑

↑

05 Adjustment is completed.

(press the PAUSE button.) Completion with ST:05, NG with ST:09

After adjustment, data is indicated at IS3 and IS4.

MONITOR