Product specifications

DC10 E, DC20 E

DISASSEMBLING

1. Disassembling and Reassembling

Notes

(1) When replacing the flat cable with a new one, allow it to remain folded the same as the original part.

(2) The flat cable has a contact orientation to be engaged with the connector. Refer to the instructions in the disassembly procedure

diagram and interconnection diagram for boards.

(3) To secure screws, apply the Three Bond 1401C (CY9-8011-000).

(4) If any part to be replaced has UL tape attached on it, be sure to reattach the UL tape at the same position when reassembling.

(5) After detaching the REAR COVER, be sure to discharge the Main Capacitor.

(Since a high voltage is applied to the Main Capacitor, take care not to receive electric shock or to shortcircuit other parts.)

Safety Precautions

(1) TS Mech safety

The laser beam is emitted in the TS Mech Recorder Ass'y.

If the laser beam gets in your eyes, it could cause eye damage, so never disassemble the TS Mech Recorder Ass'y.

(2) Precautions for handling TS Mech

This product's laser beam condenses light using an objective lens in the light pick up, so that it strikes a focal point on the disk's

recording surface. Therefore, make sure that your eyes are at least 30 cm away from the objective lens when the laser diode is

emitting light.

Note : In complete products, the laser beam is not normally emitted when the Disc Cover is open. The laser beam is

emitted when the two open/closed detection sensors near the Disc Cover are set to closed or when the Disc

Cover on a disassembled product is closed and the operation of the TS Mech Recorder Ass'y is being checked.

The laser diode wavelength of this product is from 652 to 662.5 nm, and the power consumption is below 1mW.

• Lateral engaging connector

(The instructions are given in the disassembly proce-

dure diagram and board interconnection diagram.)

: Contacts are positioned downward. (board side)

∗ : Contacts are positioned upward.

Metal contact (Pins face up)

Metal contact (Pins face down)

• Lengthwise engaging connector

(The instructions are given in the disassembly proce-

dure diagram and board interconnection diagram.)

Indicated by → Arrowheads indicate the contacts, and the

shafts indicate the noncontacts.

Metal contact