Product specifications

DC10 E, DC20 E

DISASSEMBLING

1-8 Separation of GYRO PCB

(1) Remove one screw (a × 1), and detach the GYRO GND Plate.

(2) Remove two screws (a × 2), disconnect the CN1601, and detach the GYRO PCB Section.

(3) Remove two screws (a × 2), and detach the GYRO PCB.

(4) Detach the CCD Connector Sheet from the GYRO Holder.

(1) Attach the CCD Connector Sheet as shown in the figure below.

(2) Attach the GYRO PCB Section as shown in the figure below.

Fig. 12

Metal

M1.7

2.5mm

Note on Reassembling (1)

Note on Reassembling (2)

(3)

(4)

(3) - a

GYRO PCB

GYRO GND Plate

GYRO PCB

Section

GYRO Holder

CCD Connecter Sheet

(2)

(1)

CN1601

(2) - a

(1) - a

(2) - a

(2)

GYRO PCB

GYRO Holder

CCD FPC

CCD

Connecter

Sheet

Bend it and stick it so that the face

and the back have the same length.

Insert the CCD FPC

between the GYRO PCB

and the GYRO Holder.

Attachment

reference