Product specifications

DC10 E, DC20 E

DISASSEMBLING

(1) Attach the Mode Switch as shown in the figure below.

(2) Attach the Center Cover as shown in the figure below.

(3) Insert the Multi Jack Cover after installing the Center Cover.

(4) Do not attach the Start/Stop Button at this time point.

Note : As long as the Start/Stop Button is not attached, the Disc Cover can be opened manually. Thus attach the Start/

Stop Button after all component parts are assembled.

Fig. 15

Note on Reassembling (1)

Note on Reassembling (2)

Note on Reassembling (4)

Insert into the

Main Frame

Fix Mode Switch

by sliding.

1. Fit the Mode Switch to the hole of the

Center Cover and attach two claws A.

2. While exercising care not to pinch the

Flash Cable, insert two claws B.

4. While slightly lifting up the end

section of the Center Cover,

insert the Open Knob.

End section of the Center Cover

Align with the Switch.

Start Stop Button

Open the

Disc Cover

Push it in.

Be careful not to

remove the spring.

Note

Claw A

Claw B

3. Insert the Center Cover Rib under

the Zoom Photo Unit.

Rib

Zoom Photo Unit

Open Knob

Flash Cable

ST Wire Protector

Mode Switch