Operation Manual

75
3
Sorting
Images
1
2
4
5
Introduction
Contents
Downloading
Images
Viewing
Images
Printing
Images
Editing
Images
Reference/
Index
6
Processing
Large Numbers
of RAW Images
7
Remote
Shooting
8
Specifying
Preferences
You can apply the same corrections to several images by first selecting
multiple images in the main window, and then performing correction
procedures (p.72).
Also, you can apply same corrections by copying the recipe of the
corrected image and pasting it onto the multiple images (p.91).
O Some noise appeared in the periphery of an image after
correcting [Peripheral illumination]
You can reduce the noise by using luminance and/or chromatic noise
reduction of the noise reduction function (p.64). However, if you had
applied high amount of [Peripheral illumination] correction to the
images that have been shot at night or with a high ISO speed, the
noise might not be reduced.
O The image appears with less resolution after correcting
[Distortion]
You can make the image similar to the one before correction by
applying more sharpness with the sharpness adjusting function
(p.65).
O The colors of the image became weaker after correcting [Color
blur]
You can make the image similar to the one before correction by
adjusting the color tone (p.51) and/or the color saturation (p.63) to
make the color deeper.
O The result of [Color blur] correction cannot be detected
[Color blur] correction is effective for correcting blue or red color blur
which occurs at the edge of the highlighted area of an image. If
conditions do not match, correction cannot be made.
Additional information
Correcting Multiple Images at a Time
The periphery of the image may be truncated when [Distortion]
correction is made.
This function enables the resolution of images to be increased by
removing any remaining aberration related to image-forming capability
or any deterioration of resolution resulting from diffraction phenomena.
These optical phenomena cannot be corrected under Lens aberration
correction (p.69). Correction is achieved using the designed value of
each lens. The images that can be corrected are RAW images shot
using any of the following “Compatible Lenses”. JPEG, TIFF, S-RAW,
and M-RAW images cannot be corrected. To use this function, [Lens
data] for the lens used to shoot images first needs to be downloaded to
your computer. Before using the Digital Lens Optimizer, it is
recommended that you set [Sharpness] or [Strength] for [Unsharp mask]
for images to 0.
Wide angle lenses
EF14mm f/2.8L USM EF14mm f/2.8L II USM
EF20mm f/2.8 USM EF24mm f/1.4L II USM
EF24mm f/1.4L USM EF24mm f/2.8
EF24mm f/2.8 IS USM EF28mm f/1.8 USM
EF28mm f/2.8 EF28mm f/2.8 IS USM
EF35mm f/1.4L USM EF35mm f/1.4L II USM
EF35mm f/2 EF35mm f/2 IS USM
Standard and medium telephoto lenses
EF40mm f/2.8 STM EF50mm f/1.4 USM
EF50mm f/1.2L USM EF50mm f/1.8
EF50mm f/1.8 II EF50mm f/1.8 STM
EF85mm f/1.2L USM EF85mm f/1.2L II USM
EF85mm f/1.8 USM EF100mm f/2 USM
EF135mm f/2.8
(with Softfocus mechanism)
_
Digital Lens Optimizer
Compatible Lenses