User Manual

Direct Print & Scan for Mobile V2.0 Installation and User’s Guide 29
Chapter 3 Configuring DPSM
This chapter describes how to properly configure DPSM.
3.1 Preparing the Device and Network Environment
Before you configure DPSM, you should prepare to specify the following settings:
1. Specify the Network Settings.
2. Make sure that your smartphone, tablet, iPad, or iPhone is on the same Wi-Fi
network or VPN as where the MEAP device is located.
3. Disable SSL communication. (Only if you are using an iPhone or iPad running 5.x
or higher.)
3.1.1 Specifying the Network Settings
Make sure that the correct IP address is set on the machine, and specify the necessary
network settings by pressing (Settings/Registration) ➞ [Preferences] ➞
[Network].
IMPORTANT
• If the device is already operating on the network (i.e., documents can already be
printed or sent from a computer), this operation is not necessary.
• For more information on specifying the Network settings, see the Network
e-Manual that came with your machine.