Operation Manual
Table Of Contents
- DR-2010C/DR-2510C/DR-2010M/DR-2510M User Manual
- Introduction
- Contents
- Chapter 1 Before Using the Scanner
- Chapter 2 Setup
- Chapter 3 Basic Operation
- Chapter 4 CaptureOnTouch Settings
- Chapter 5 Other Scanning Methods
- 1. Scanning with CapturePerfect 3.0
- 2. Basic Scanning Procedure
- 3. Using the Scan Panel
- 4. Special Scanning
- Enhancing the Text of a Document
- Scanning Documents That Include Both Color and Black-and-White Pages
- Scanning Different Sized Documents Together
- Skipping Blank Pages
- Scanning (Single-Sided) 11" X 17"/A3 Documents
- Deskewing Documents
- Moire Reduction
- Correcting the Text Orientation of Documents
- Reducing Bleed Through for Thin Documents and Documents with Dark Reverse Sides
- Deleting Borders and Ruled Lines of a Specified Color (Red/Green/Blue)
- Enhancing the Red color for Black-and-White Scanning
- Creating Smaller Files
- Saving the Text Data of Documents as Search Keywords
- Specifying Security Settings for PDF Files (Windows only)
- Chapter 6 Scanner Driver Settings
- 1. Before Using the Scanner
- 2. Scan driver settings
- Scan Mode Settings
- Auto Color Detection
- Paper Size Settings
- Scan Resolution Settings
- Scanning Side Settings
- Correcting Image Skewing
- Moire Reduction
- Adjusting the Scan Area
- Brightness/Contrast Adjustment
- Gamma Curve Settings
- Image Contour Adjustment
- Image Rotation
- Correcting Text Orientation
- Removing the Document Background/Preventing Bleed Through
- Omitting a Specific Color
- Enhancing the Red Color
- Rapid Recovery System
- Double Feed Detection
- Feeding Options
- Prescan
- Registering Scanning Conditions
- Checking the Version
- Chapter 7 Maintenance
- Chapter 8 Troubleshooting
- Chapter 9 Appendix
- INDEX
Back Previous Page Next Page
Contents
67
NOTE
• The settings you can specify are as follows.
- [Color Saturation/Proportion of Color]
Normally scan with the default values (Color Saturation: 2, Proportion of Color:
2), but change the settings when you want to scan a color document as a black-
and-white document.
y Color Saturation: change the setting towards "High" when you want to scan a
color document with low color saturation as a black-and-white document.
y Proportion of Color: change the setting towards "High" when you want to scan
a colordocument with a low proportion of color as a black-and-white
document.
- [Mode in case of binary]
Select the scanning mode when a page is detected as black and white.
- [Brightness]
This setting adjusts the brightness when [Advanced Text Enhancement] (only for
Windows) or [Advanced Text Enhancement II] is selected with the Black and
White mode. For other modes, the brightness is set from the [Brightness] tab.
The brightness setting for other modes is dependent on the following settings.
Windows: [Brightness] under [Brightness] tab
Mac OS X: [Brightness] under [Brightness/Contrast]
- [Contrast]
This setting adjusts the contrast when [Advanced Text Enhancement II] is
selected with the Black and White mode. For other modes, the contrast is set
from the [Brightness] tab. The contrast setting for other modes is dependent on
the following settings.
Windows: [Contrast] under [Brightness] tab
Mac OS X: [Contrast] under [Brightness/Contrast]
This section describes the procedure for selecting the size for scanning.
Under Windows
1
Click the [Basic] tab → click the page size in [Page Size].
Paper Size Settings