Owner's Manual

16
Power switch
Setting up the scanner
In the case of “Update Device Driver Wizard” (Windows 95), click Next and then click Finish on
the next screen.
In the case of “Add New Hardware Wizard” (Windows 98), follow the procedure described
below.
1 . Click Next.
2 . Select “Search for the best driver for your device (Recommended)” and then click next.
3 . Clear all checkmarks and then click Next.
4 . Click Next.
5 . Click Finish.
In the case of “Add New Hardware Wizard” (Windows Me), select “Automatic search for a
better driver (Recommended)”, then click Next and then click Finish on the next screen.
In the case of “Found New Hardware Wizard” (Windows 2000), follow the procedure described
below.
1 . Click Next to advance to the “Install Hardware Device Drivers” screen.
2 . Select “Search for a suitable driver for my device (recommended)”, and then click Next to
proceed to the “Locate Driver Files” screen.
3 . Clear all of the checkmarks in the “Optional search locations”, and then click Next to pro-
ceed to the “Driver Files Search Results” screen.
4 . Select “Disable the device.” and then click Finish.
With the “Found New Hardware Wizard” (Windows XP), select “Install the software automati-
cally (Recommended)”, then click Next, select “Don't prompt me again to install this software”,
and click Finish.
• You must install the scanner driver before using the scanner. Refer to the “ISIS/TWAIN Driver
User’s Manual.”
Switching the scanner on/off
1
To power the scanner on, press the
power switch to the on position (|).
The power lamp flashes green while the
scanner warms up. When the power
lamp lights green and remains on, the
scanner is ready for operation.
2
To power the scanner off, press the
power switch to the off position (O).
The power lamp extinguishes.