Owner's Manual

26
Summary of the Imprinter menu modes and settings
Number, mode and
Content
default display
01 Setting the imprinter data Uses the imprinter to stamp the front sheet of each scanned page
with text you specify.
Host Count
Host: Prints the text specified with the software application on the
computer.
Count: Prints according to the counter setting for “Select the counter
displayed on LCD”. (Counter menu, mode 01)
02 Setting the imprinter Specifies the starting location of the stamp printed by the
imprinter if Count was selected for 01 above.
Press a select arrow key (
) to specify the position on the page where
the stamp will print. If zero is entered, the stamp prints 10 mm from the
top edge of the page.
Example: 2 Letter Text Setting
02.Pre P
<1Char>
os i t ion
12.4mm
The mm setting tells you the approximate distance of the starting posi-
tion from the top of the page.
Enter a text string 0 (10 mm or 0.4 in.) to 72 characters wide (182.8 mm
or 7.2 in.)
Here is an illustration of the example above. The two letters print 14.8
mm (0.6 in.) from the top.
Top of the paper
14.8mm
(0.6in.)
10mm
(0.4in.)
4580
4580
Top of the printout when
the imprinter start position
is set to 2 characters.
Spaces fill out stamps shorter
than 7 characters.
[
[
[
[
[
[
The count must be printed with 7-digit numbers. Numbers shorter than
7-digits are counted as spaces and not printed.
03 Setting the imprinter Orientation This sets the orientation of character printing when using the
imprinter.
Host 0° 90° 180° 270°
Prints portrait orientation.
Rotates character string 90 degrees and prints.
Print portrait orientation from the end of
the character string.
0°
90°
180°
270°
Rotates character string 270 degrees and prints.
A
B
A B
A B
A
B
:Transfer direction
Setting up the scanner
01.Pre Impr i nt
Hos t
start position
02.Pre P
<0Char>
os i t ion
10.0mm
03.Pre Rotate
Hos t