Owner's Manual

28
Summary of the Others menu modes and settings
Number, mode and
Content
default display
01 Checking the firmware version Displays the firmware version of the mechanical control and
imprinter.
xxxM: Amount of expansion memory installed in the scanner. Does
not appear if no expansion memory is installed.
Mx.xx: Mechanical control firmware version.
Fx.xx: Firmware version of the imprinter. Does not appear if the
optional imprinter is not installed.
02 Setting the buzzer Switches the scanner buzzer alert off and on.
02.Buzzer
ON
ON OFF
When the buzzer is on:
1 buzz: Short buzz every time a key is pressed.
1 buzz: Long buzz after every scanning job completes normally.
5 buzzes: Error
03 Setting the SCSI ID Sets the SCSI ID number for the scanner.
03 . SCS I I D
No . 0
No.0 No.1 No.2 No.3 No.4 No.5 No.6 No.7
After you select a number for the SCSI ID number, press Home then
switch the scanner off and switch it on again.
04 Setting the terminator Activates and deactivates the terminator.
04.Terminator
Disable
Disable Enable
Select Enable if the scanner is the last device on the SCSI device chain.
Even if Enable is selected, the scanner’s terminator does not function
when the power is turned off. In this case, connect a standard SCSI
terminator if you will be using the computer with the scanner powered
off.
Changes in this setting become effective after the power is cycled off
and on.
05 Setting the transfer rate
20MByte/sec 10MByte/sec
Changes the maximum synchronous transfer rate of the SCSI inter-
face.
If the computer does not detect the scanner or you encounter prob-
lems with scanning, try lowering the synchronous transfer rate to 10
Mbyte/sec.
06 Checking the Clean Roller Tells you when it is time to clean the rollers. When this display
nears 100% clean the rollers.
100%: Rollers must be cleaned. (➞ 41)
0%: Displayed after setting is cleared (see 06 below).
06 Clearing the Clean Roller Press
together to clear the Clean Roller Warning. After the
warning is cleared and reset to 0%, “Completed” is displayed in
the LCD.
Setting up the scanner
01.Vers i on
Warning status
06.Cl ean
Wa r n i n g
Ro l l e r
0%
Warning
06.Cl ean
Wa r n i n g
Ro l l e r
Clear=<>
05.Transfer Rate
20MBy te/ sec