Setup guide

105
6 Remove the jammed document. 7 Close the front unit by gently pushing it up on both sides until it clicks
into place. Make sure that the front unit is completely closed by
pushing until you hear a click.
After removing the jammed paper, check to see if the last page was scanned
correctly, and then continue scanning.
Make sure to pull the document out carefully, without applying too much
force. If the jammed paper tears while you are pulling it out, make sure to
remove any remaining pieces from inside the scanner.
When a paper jam or other problem occurs while [Rapid recovery
system] is enabled in the scanner driver, the image of the last
document that was scanned properly is saved before scanning is
stopped. Therefore, you can quickly resume scanning after
resolving the cause of the interruption. As the image of the
document that was being fed at the time of the interruption may not
be saved in such cases, be sure to verify the last scanned image
before resuming the operation.