Setup guide

55
Scanning Shortcut setting
###HOME > Chapter 6 Scanning with CaptureOnTouch > Scanning
Shortcut setting###
By default, CaptureOnTouch Lite enables the [Full auto] scan setting,
so scanning is implemented using the scan conditions that match
the document.
To specify combinations of document selection and outputs, you can edit
the scanning shortcut panel to set the desired scanning shortcut.
Creating new [Scanning Shortcut] panels
There are two ways as described below to create a new Scanning
Shortcut panel.
z Click the [Save to Shortcut] button in [3 actions] in Standard Scanning
to register the selected output and document scan to one of the
scanning shortcut panels.
z Click the [New shortcut] button to add [New scanning shortcut] panel.
Click to display the list of panel types. The selected type of the
panel is created.
Editing new [Scanning Shortcut]] panels
When the Edit button is clicked, the Scanning Shortcut panel editing
dialog will appear.
The following tabs are on the Edit Scanning Shortcut panel screen.
z [SCAN] Tab
z [Select output] Tab
z [Option] Tab
z [General] Tab
About file formats
###HOME > Chapter 6 Scanning with CaptureOnTouch > About file
formats###
Set the file format of the scanned image. When you select a file
format other than BMP or PNG, the [Detail Settings] button is
enabled, allowing you to make the detail settings for the selected file
format.
You can select one of the following file formats for the scanned
image.
z PDF format
z TIFF format
z PNG format
z JPEG format
z BMP format
z PPTX format (File format for Microsoft PowerPoint 2007 and
later)
The file formats that can be selected vary depending on the
destination setting.
When you output the scanned image using the plug-in, the image is
output in the file format set in the application of the plug-in.
Therefore this file format may be different from the one selected in
the Select document panel.