User Manual

36
Load a fully charged Battery Pack LP-E10 into the camera. You can use
an SD, SDHC, or SDXC memory card (sold separately) with the
camera. The captured images ar
e recorded onto the card.
Make sure the card’s write-protect switch is set upward to
enable writing and erasing.
1
Open the cover.
 Slide the lever as shown by the
arrows and open the cover.
2
Insert the battery.
 Insert the end with the electrical
contacts.
 Insert the battery until it locks in
place.
3
Insert the card.
 As shown by the illustration, face
the card’s label side toward the
back of the camera and insert it
until it clicks in place.
4
Close the cover.
 Press the cover until it snaps shut.
 When you set the power switch to
<1>, the number of possible shots
(p.40) will be displayed on the LCD
monitor
.
Installing and Removing the Battery and Card
Installing the Battery and Card
Write-protect switch