User manual

Displaying the Status Screens
196
Displaying the Status Screens
You can use the status screens to check the camera’s various settings. You can also output the status screens
to an external monitor.
1 Set an assignable button to [Status] in advance (A 135).
2 Press the assignable button to open the status screens.
• The status screen most recently displayed will appear unless you turned off the camera or changed the
operating mode. In such case, the [Gamma/Color Space/Color Matrix] status screen appears in
mode and the [Assignable Buttons 1/3] status screen appears in mode.
3 Push the joystick up/down or turn the SELECT dial to scroll through the status screens.
4 When you have finished, press the assignable button set to [Status] again to exit the status screens.
• Alternatively, you can press the CANCEL button.
In the following pages you can find more details about the information displayed on the status screens.
When the optional WFT-E6 or WFT-E8 Wireless File Transmitter is attached to the camera, four [Network
Settings] status screens will be displayed as well. For details about these status screens and all network
settings, refer to the ‘WFT-E6/WFT-E8: Guide for EOS C300 Mark II Users’ (PDF file).
[Gamma/Color Space/Color Matrix] screen A 196
[CP Data] screens A 197
[Camera] screens A 198
[Assignable Buttons] screens A 199
[Audio] screens A 200
[Media] screen A 200
[Video] screens A 201
[Metadata] screens A 202
[Battery/Hour Meter] screen A 202
[GPS Information Display] screen*A 203
*Only when the optional GP-E1 GPS Receiver is attached to the camera’s
system extension terminal.
[Gamma/Color Space/Color Matrix] Status Screen ( mode only)
Operating modes:
2
1
1 Gamma curve, color space and color matrix used
for recordings, video output and displays
[CFast]: Settings used for primary clips recorded
on the CFast card (A 139, 143)
[SD Card]: Settings/LUT used for proxy clips
recorded on the SD card (A 115)
[MON.], [REC OUT], [HDMI]: Settings/LUT used
for video output from the respective terminals
(A 173)
[LCD/VF]: Settings/LUT used for the camera’s
LCD screen and viewfinder (A 173)
2[/ Custom Picture] > [Other Settings] >
[Activate] setting (whether detailed settings in the
custom picture file are active or not)