User manual

Preparing the Camera

Using a Tripod

The camera is shipped with the TB-1 Tripod Base for tripods with 0.95 cm (3/8") screws.

You can mount the camera on a tripod but do not use tripods with mounting screws

longer than 5.5 mm (0.2 in.) as this may cause damage to the camera.

Using a Tripod with 0.64 cm (1/4") Mounting

Screws

To use a tripod with 0.64 cm (1/4") mounting screws, first

attach the supplied tripod adapter base to the camera

and then attach the tripod to the adapter base.

1 Remove the original TB-1 Tripod Base from the

camera.

• Remove the 4 screws and then remove the base.

2 Attach the supplied tripod adapter base for 0.64 cm

(1/4") tripods.

• Firmly screw in the 4 screws.

3 Attach the tripod.

• Firmly screw in the tripod screw.

Removing and Attaching the Grip Unit

The grip unit comes originally attached to the camera. You can remove it and replace it with the thumb rest

should the minimal configuration be necessary.

Removing the Grip Unit

1 Set the Q switch to OFF.

2 Unscrew the grip unit’s lock screw and gently detach

the grip unit.

• The grip unit contains an internal connection cable

so be sure not to pull it too forcefully.

3 Disconnect the grip unit’s connection plug.

4 Screw the thumb rest onto the camera.

5.5 mm

햲

햳

햴

햵