User manual

45
Preparing the Camera
Attaching the Grip Unit
The grip unit can be attached in any of 24 positions (at
15º intervals) to give you a convenient grip angle for
high- and low-angle shooting.
1Set the Q switch to OFF.
2 Unscrew the thumb rest and remove it from the
camera.
3 Firmly insert the grip unit’s plug all the way into the
grip unit connection terminal on the camera.
• Make sure to insert the plug all the way in, until the
white line around the terminal is not visible.
• If the plug is not correctly connected (for example, if
the white line around the terminal is partly visible), all
the controls on the camera may be disabled.
4 Attach the grip unit to the camera aligning it at the
desired angle and tighten the grip unit’s lock screw.
Adjusting the Grip Belt
Adjust the grip belt so that you can reach the START/STOP button on
the grip unit with your index finger but still have a comfortable but
secure grip.
Attaching the Handle Unit
1 Attach the mounting bracket to the camera.
• Use the supplied hex wrench to secure the bracket firmly with
3 of the supplied hex socket head screws.
2 Attach the handle unit to the mounting bracket.
• Secure the handle unit firmly with 2 of the supplied hex socket
head screws.
NOTES
• The handle unit has 0.95 cm (3/8") and 0.64 cm (1/4") sockets
and the mounting bracket has additional 0.64 cm (1/4") sockets,
giving you multiple options to attach a variety of commercially
available accessories.
햳
햴
햵
White line
햲
햳