User manual

81
Adjusting the Focus
Manual Focus
Focus manually using the focus ring on the lens. You can also perform this function remotely using Browser
Remote on a connected Wi-Fi device (A 124, 129).
The autofocus mode is set to [One Shot] by default. If you need to change the setting, start the procedure from
the beginning. Otherwise, you can start from step 3 below.
1 Open the focus [AF Mode] submenu.
[v Camera Setup] > [Focus] > [AF Mode]
2 Select [One Shot] and then press SET.
3 Press the FOCUS GUIDE button to display the focus guide.
4 On the LCD screen, touch the subject to focus on.
1
• Alternatively, you can push the joystick up/down/left/right.
• You will not be able to touch the subject if the focus guide is not
displayed.
• For details on using the focus guide, refer to
Dual Pixel Focus Guide
(A 82).
1
Only when the optional LM-V1 LCD Monitor is attached.
5 Turn the focus ring to adjust the focus.
• On an EF lens, set the lens’s focus mode switch to MF. On a
compatible EF Cinema lens, enable manual adjustment on the lens
(A 80).
NOTESNOTES
• With some EF lenses, you may be able to operate the focus ring even
when the focus mode switch is set to AF.
• If you operate the zoom after focusing, the focus on the subject may be lost.
• If you focus manually and then leave the camera with the power turned on, the focus on the subject may be
lost after a while. This possible slight shift in focus is a result of the internal temperature rising in the camera
and lens. Check the focus before resuming shooting.
• When adjusting the focus, be careful not to touch the front of the lens or moving parts on the lens except for
the focus ring.
• When an optional RC-V100 Remote Controller is connected to the camera, you can adjust the focus with the
remote controller’s FOCUS dial. At default settings, turn the dial right to focus farther and left to focus nearer.
[v Camera Setup]
[Focus]
[AF Mode]
[One Shot]
FOCUS
GUIDE
button